PRO CNC Vertical Workholding¶
- Remove the indicated gussets from the side opposite of the electronics bar.
- Install the provided second electronics bar at 120mm (4-23/32") from the bottom of the table. It may be helpful to clamp pieces of wood cut to 120mm, as shown, for spacing and installing the second electronics bar.
Assembly Note
Make sure that your original electronics bar is also spaced 120mm from the bottom of the table. It will need to be aligned with the new electronics bar.
- Reinstall the gussets as shown.
- Install the lower crossmember so it is aligned with the 2nd crossmember.
- Install your preferred vertical spoilboard.
- Install a spoilboard to fit.
- Alternatively, after the second electronics bar is installed, you can recess the front member a desired amount.
- Align the lower crossmember with the now recessed front crossmember.
- Install your preferred vertical spoilboard.