Skip to content

System Settings

DIP switch Settings

DIP switch settings on the motor drives will vary depending on your application. The DIP switch positions are shown below.

CRP8070 for 7.0A 1/2" NEMA 34 motors

7A Motors

CRP5056 for 4.2A 3/8" Nema 23 motors

3.5A Motors

If you are using an Avid CNC rotary axis on a NEMA 23 system, be sure the rotary axis motor is hooked up to the 5th drive with that drive's DIP switch positions are set as shown below.

CRP5056 for 5.0A motors

5.0A Motors

ESS Jumper Settings

Jumpers

The jumper pins shown here can provide 5V to pin 26 of their adjacent header, port 1 or port 2. The ESS comes pre-configured in the CNC controller with these jumpers connected on port 1 and port 2.