System Settings¶
DIP switch Settings¶
DIP switch settings on the motor drives will vary depending on your application. The DIP switch positions are shown below.
If you are using an Avid CNC rotary axis on a NEMA 23 system, be sure the rotary axis motor is hooked up to the 5th drive with that drive's DIP switch positions are set as shown below.
ESS Jumper Settings¶
The jumper pins shown here can provide 5V to pin 26 of their adjacent header, port 1 or port 2. The ESS comes pre-configured in the CNC controller with these jumpers connected on port 1 and port 2.