Section 2: Rack & Pinion Drive Installation¶
Note
Installation is shown using Avid CNC extended linear carriages and gear rack.
2.1 Drive Installation¶
2.1.1¶
- Attach an R&P Assembly to the linear carriage as indicated.
2.1.2¶
- Install R&P Tensioner Bracket and Tension Post as indicated.
- Partially tighten fasteners.
2.1.3¶
- Install tensioner screw as indicated and hand tighten.
- Tighten R&P Tension Bracket M8 x 10mm fastener.
2.1.4¶
- Partially remove the tension screw as indicated.
- Tighten R&P Tension Post fastener indicated by the red arrow.
2.1.5¶
- Hand tighten tension screw until finger tight.
- Set initial R&P tension by tightening tension bolt three additional turns.