Section 2: PRO R&P Drive Installation¶
Section Note
Parts and Tools Required¶
| QTY | Part/Description |
|---|---|
| 1 | CRP320-00-TEN-19.1 |
| (1) R&P Tension Post | |
| (1) R&P Tension Bracket | |
| (1) M6 x 12mm Flat Head Screw | |
| (1) M8 x 14mm Hex Cap Screw | |
| (1) M8 x 90mm Hex Cap Screw | |
| (2) M8 Flat Washer | |
| (1) Die Spring | |
| 1 | CRP320-00-FAST-XXX |
| (1) Eccentric Collar Bearing Cap | |
| (1) Pivot Shaft |
2.1 Drive Installation¶
2.1.1¶
- Attach the tension post to the R&P plate as indicated.
- Partially tighten the fastener.
2.1.2¶
- Attach the tension bracket to the riser plate as indicated.
- Partially tighten the fastener.
2.1.3¶
- Attach the R&P assembly to the riser plate as indicated.
Assembly Note
Ensure the eccentric collar bearing cap is oriented correctly. It will fit over the eccentric collar bearing pre-installed in the R&P drive plate.
2.1.4¶
- Ensure the R&P assembly is fully seated on the riser plate as indicated.
2.1.5¶
- Fully tighten the pivot shaft.
Assembly Note
There will be a gap between the head of the pivot shaft and the eccentric collar bearing, as shown by the arrow.
2.1.6¶
- While pushing in on the eccentric collar bearing, rotate it in the clockwise direction until it starts rotating inside the R&P plate.
- Hold the eccentric collar bearing in this position while proceeding to the next step.
2.1.7¶
- Tighten the set screw on the side of the eccentric collar bearing.
2.1.8¶
- Install the tension bolt, washers, and spring as indicated.
Assembly Note
Only thread the bolt through the first hole of the tension post.
2.1.9¶
- Tighten the tension post fastener
2.1.10¶
- Continue threading in the tension bolt until the spring is seated, but not compressed.
- Fully tighten the tension bracket fastener.
2.1.11¶
- Tighten the tension bolt 3 revolutions to tension the R&P Assembly.