PRO Rack and Pinion Drive, NEMA 34

PRO CNC

Standard CNC

Benchtop CNC

Plasma CNC

Electronics

Tooling

Other Products

Media & Info

Tell A Friend

PRO Rack and Pinion Drive, NEMA 34

Our PRO Rack and Pinion Drives offer tighter interfaces and higher accuracy than our standard line, with the following features:

Our most recent version features some significant improvements in usability over previous models.

Top-side belt tensioning cam. Belt tension can be adjusted without clamps, even while the unit is installed on a machine.
Universal mounting plate design allows users to switch from NEMA 34 to NEMA 23 by changing only pulleys, belts, and drive spindle.
Dual bearing pivot with eccentric locking collar for low backlash and easy adjustment of rack engagement in non-standard setups.

Package includes:

Rack and Pinion drive plate with universal mounting features for NEMA 23 or NEMA 34 motors.
Pre-assembled dual bearing pivot system with precision shoulder bolt (3/8-16 thread).
1/2" bore motor pulley.
Super oilite bearing drive spindle, with 20 tooth gear and 64 tooth timing pulley and matched precision ground shaft.
5mm pitch timing belt.
Belt tension cam mechanism.
Motor mounting screws and nuts (motor not included).
Pro-tension kit.

Product Notes:

Motor not included.
Pair this drive system with our 960 oz-in NEMA 34 Motor for superior machine performance.
PRO R&P drives interface perfectly with our PRO Gear Rack, available in 39" or 52" sections that are conveniently spliceable for virtually unlimited travel, using 20 pitch, 20 degree pressure angle rack featuring a mounting flange for easier installation, greater stiffness, higher load capacity, and longer gear life.

The R&P system is based on a pinion with a 1" pitch circle. The total linear distance traveled per revolution of the pinion is thus 3.14159". With the 3.2:1 reduction, this means that the distance traveled per motor revolution is 3.14159 / 3.2, or 0.9817". If you have a stepper with 200 steps per revolution, this means you have 200 / 0.9817" = 203.718 steps per inch, or 0.004908" per step. With 10x microstepping , you would have 2037.18 steps per inch, or 0.0004908" per step.

Plans

Documentation

$199.75

This product was added to our catalog on February 25, 2013.

Customers who bought this product also purchased

ER32 Collet	SheetCam Plasma CAM Software	PRO CNC Plasma Kit

Dewalt DWP611 Router Mount	8.7 HP Spindle Tramming Mount	ER32 Collet and Nut Set, Imperial